Commissioning Of The Pump Drive (Motor Control); Commissioning The Pump; General Notes About Commissioning The Pump - Bosch Rexroth Sytronix FcP 50 Series Operating Instructions Manual

74/143 Bosch Rexroth AG
Commissioning
9.3

Commissioning of the pump drive (motor control)

9.4

Commissioning the pump

9.4.1

General Notes about Commissioning the Pump

LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
Rexroth Sytronix FcP 50xx/70xx Motor-Pump Unit MPES2
For details on the commissioning order, please refer to the respective docu‐
mentation of the drive controller or firmware description.
Please observe the general safety instructions on the protection against haz‐
ardous movements.
For commissioning the pump, necessarily observe the operating instruction of
the hydraulic system.
Commissioning of the pump requires basic mechanical and hydraulical
knowledge.
● The commissioning of the pump may only be done by skilled personnel
(refer to "Rexroth Sytronix, Safety Notes and Instructions on Use, Mo‐
tor-Pump Unit", MNR R911339831).
If the pump has not been assembled correctly, persons could be injured and
the product or the system could be damaged when commissioning the pump.
● Ensure a correct assembly of the pump by qualified personnel before
you take the pump into operation.
NOTICE
● When commissioning the product, provide for absolute cleanness.
● Make sure that no contamination may penetrate when sealing the meas‐
uring connections.
NOTICE
● When commissioning or re-commissioning a machine and/or system
make sure that the suction and pressure lines of the pump are filled with
hydraulic fluid and remain filled also during operation.
DOK-SYTROX-MPES2******-IT01-EN-P
Contaminated hydraulic fluid could result in
wear and tear and malfunctions. In particular‐
ly foreign bodies like e.g. welding beats and
metal cuttings in the suction line may damage
the pump.
When commissioning the pump with or with‐
out hydraulic fluid, the pump is damaged or
even damaged immediately.