Software And Hardware Preconditions - Siemens SINUMERIK 840D sl Commissioning Manual

Requirements for commissioning

3.2 Software and hardware preconditions

3.2 Software and hardware preconditions
Requirements for commissioning
For the commissioning of SINUMERIK 840D sl, the following points are required:
● Hardware requirements
– NCU with TCU
– CompactFlash card
– Dual fan/battery module for NCU
– Optional: PCU 50.5 with Windows 7 and operator panel
● Connection to NCU
– Network switch to X120
– Ethernet machine control panel to socket X120
– Ethernet connection from PG/PC to X120 or X127 for commissioning the PLC
– Ethernet connection from the TCU to the Ethernet machine control panel
– Optional: Ethernet connection from the PCU to the Ethernet machine control panel
● Software requirements
– CNC software with SINUMERIK Operate
– Optional: SINUMERIK Operate for operation on the PCU
– SIMATIC STEP 7 on PG/PC (engineering system)
– SINUMERIK 840D sl Toolbox for STEP 7 package
– GSD files (Toolbox)
32
Note
For the operation of SINUMERIK Operate on the PCU without TCU, the "HMI"
subsystem for SINUMERIK Operate on the NCU must be switched off.
Note
The part numbers of the SINAMICS drives, encoders and motors should be available for
parameterization.
CNC Commissioning: NC, PLC, Drive
Commissioning Manual, 12/2019, A5E48312804B AA