Stamina DT 397 Owner's Manual page 11

ASSEMBLY INSTRUCTIONS
STEP 8
There is an "L" decal on the left PEDAL CAP(43L), and an "R" decal on the right PEDAL CAP(43R). Insert
the PEDAL SHAFT(6) through the tube located on the MAIN FRAME(1). Slide the left PEDAL CAP(43L)
onto the left side of the PEDAL SHAFT(6). Slide the right PEDAL CAP(43R) onto the right side of the
PEDAL SHAFT(6). Then secure the PEDAL CAPS(43) with BUTTON HEAD BOLTS(M8x1.25x15mm)
(66), LOCK WASHERS(68), and FENDER WASHERS(M8)(96) at both ends of the PEDAL SHAFT(6).
You need to use two Allen Wrenches to tighten the BUTTON HEAD BOLTS(M8x1.25x15mm)(66) at both
ends of the PEDAL SHAFT(6) at the same time.
STEP 9
Install two AAA batteries into the METER(14), the batteries are not included. See page 12 for detailed battery
installation instructions. Check the SENSOR WIRES(16) at the back of the METER(14) are connected
securely. Adjust the METER(14) to the proper angle for using.
66
68
96
43L
L
6
14
11
1
96
43R
R
68
66