HP 53150A Series Programming Manual page 30

Table 2-1. IEEE 488.2 Common Commands
Mnemonic
*CLS
*DDT <arbitrary block>
*DDT?
*ESE <NRf>
*ESE?
*ESR?
*IDN?
*IST?
*OPC
*OPC?
*PRE <NRf>
*PRE?
*RCL <NRf>
*RST
*SAV <NRf>
*SRE <NRf>
Chapter 2 Command Summary
HP 53150A/151A/152A Command Summary
Command Name
Clear Status
Define Device Trigger
Command
Define Device Trigger
Query
Standard Event Status
Enable
Standard Event Status
Enable Query
Event Status Register
Query
Identification Query
Instrument Status
Query
Operation Complete
Operation Complete
Query
Parallel Poll Enable
Register
Parallel Poll Enable
Register Query
Recall
Reset
Save
Service Request Enable Sets the Service Request Enable register.
2-10
Function
Clears all event status registers summarized in the
status byte and empties the Error Queue.
Defines which command is executed when the
Counter receives a GET or *TRG command.
Queries which command is executed when the
Counter receives a GET or *TRG command.
Sets the Standard Event Status Enable Register.
Queries the Standard Event Status Enable Register.
Queries and then clears the Standard Event Status
Register.
Queries the Counter identification.
Queries the current state of the parallel poll response
(Instrument Status).
Causes Counter to set the operation complete bit in
the Standard Event Status Register when all pending
operations (see Note at the end of table) are finished.
Places an ASCII "1" in the Output Queue when all
pending operations (see Note at the end of table) are
completed.
Sets the value of the Parallel Poll Enable register.
Queries the value of the Parallel Poll Enable register.
Restores the state of the Counter's user settings from
a copy stored in local non-volatile memory (0 through
9 are valid memory registers).
Resets the Counter to a known state, as defined in
this manual.
Stores the current state of the Counter's user settings
in local non-volatile memory (0 through 9 are valid
memory registers).
Programming Guide