HP 53150A Series Programming Manual page 109

Chapter 4 Command Reference
:INPut Subsystem
:INITiate[:IMMediate]
COMMAND
This event command causes the instrument to initiate either a single
measurement or a block of measurements.
COMMENT
RELATED
FRONT-PANEL
KEYS
:INPut Subsystem
This subsystem controls the characteristics of the Counter's input ports.
:INPut:FILTer:[:LPASs][:STATe] . . . <Boolean>
COMMAND
Sets or queries the state of the Channel 1 low-pass filter.
•
QUERY RESPONSE
•
*RST: OFF
COMMENT
Shift + Menu (CH1 LPF > OFF | ON)
RELATED
FRONT-PANEL
KEYS
Programming Guide
This command is an overlapped command (see IEEE 488.2, Section
12). Beginning a measurement or block of measurements with an
:INITiate[:IMMediate] sets the Pending Operation Flag to true.
Completing the measurement or block of measurements (normally or
by aborting) sets Pending Operation Flag to false.
None
Single ASCII-encoded byte, 0 or 1.
A value of 0 indicates OFF; a value of 1 indicates ON.
4-9