Table of Contents
Advertisement
Preset Download
Before performing the following steps, be sure to finish Preparation on page 11.
¶
1
If you are referring to the display window, press
5
∞
/
to select "CH – –" and press OK or 4.
Channel position number increases from
"CH 1".
Do NOT press any button on the front panel or remote control until the display
window shows either the display as illustrated in step 2 or "– –:– –".
2
If the correct current time is displayed on the display window, the Auto Channel Set and Clock Set
have been completed successfully. Go to step 3.
If "1" (channel position) is displayed on the display window, the Auto Clock Set has not completed
(only the Auto Channel Set has). Go to step 3 and then perform "Clock Setting" manually. ( P.20)
¶
You can check if the Guide Programme numbers have been set correctly when you perform
Recording ( P.29); if the correct channel position number is displayed on
confirms that the Guide Programme number for
3 Set the Video Channel manually. ( P. 14)
4 Press PROG. +/– to make sure that all necessary stations have been stored in the VCR's memory.
¶
If station names (ID) ( P.18) have also been stored in the VCR's memory, the station name will be displayed at the
top left corner of the screen for about 5 seconds when the VCR is tuned to a different station.
¶
If you want to set the tuner manually such as to add or skip channels, to change channel positions, or to set station
names, see pages 16–17.
¶
If no station is stored in the VCR's memory, make sure the SCART cable is connected correctly and press OK to re-
perform Preset Download.
Notes:
¶
In the area where no TV station transmits a PDC signal, the VCR can perform neither auto clock set nor auto Guide
Programme number set.
¶
If there is a power cut, or if you press STANDBY/ON, VCR POWER or MENU while downloading or set up is on progress, it will be
interrupted; be sure to turn off the VCR power once and try again from the beginning.
¶
Auto clock may not function properly depending on the reception condition.
¶
When you perform Preset Download function, be sure to use fullywired 21-pin SCART cable.
¶
On this VCR, the characters available for station's name (ID) are A-Z, 0-9, -, *, + and
may differ from those of your TV ( P.18)
Important
7
In certain reception conditions, station names may not be stored correctly, and auto Guide Programme Number Set may not work
properly. If the Guide Programme numbers are not set properly, when you timer-record a TV programme using
the VCR will record a TV programme of a different station. When programming the timer using
check whether the channel position on which your VCR receives the broadcasting station you wish to record is selected. ( P.29)
¶
If you are referring to the on-screen display, press
to select "FOLLOW TV" and press OK or 4.
AUTO SET
FOLLOW TV
=
5 ∞
[
]
[MENU] : EXIT
the PlusCode
number you enter has been set correctly.
— 13 —
FOLLOW TV
PLEASE WAIT
[MENU] : EXIT
GUIDE PROG SET
PLEASE WAIT
[MENU] : EXIT
VIDEO Plus+
the VIDEO Plus+
Programme screen, this
(space). Some downloaded station's name
VIDEO Plus+ system,
VIDEO Plus+ system,
5
∞
/
Timer
be sure to
Hide quick links:
Advertisement
Table of Contents
