Table of Contents
Advertisement
Memory
001 - START
•
Power off the system unit.
•
Ensure that all DIMMs are installed correctly.
•
Power on the system unit.
•
Run the Diagnostics program located in service
partition.
•
Take note of any messages, error codes, or
symptoms.
002 - DO YOU RECEIVE POST MEMORY ERROR
MESSAGE? (YES, READ AHEAD. NO, GO TO
STEP003)
•
Enter Configuration/Setup Utility then reboot the
system. Take note of any messages, error codes,
or symptoms. If the error message remains, go to
step 005.
003 -
•
Follow the screen instructions to run the Memory
test.
004 - DOES THE MEMORY TEST COMPLETE
WITHOUT AN ERROR? (YES, READ AHEAD. NO,
GO TO STEP005)
•
The system memory is now functioning correctly.
If you suspect an intermittent problem, run the
Memory test again.
•
End.
005 -
•
Replace the defective DIMM based on the result
of running Diagnostics program, with a known
working DIMM of the same size and type.
•
If the problem does not appear, it means that the
last DIMM replaced is defective. If all DIMMs on
the system board, have been replaced and the
problem remains, replace system board.
•
Go to step 001.
NOTE: If system board has no memory installed, you
will hear L-L-S-S-S. (L: long beep, S: short
Check Procedures 67
Advertisement
Table of Contents
