IBM 2283 Hardware Maintenance Service page 89

NOTE: If you cannot access the hard disk drive or
load a diskette from Drive A or load a CD from
the CD-ROM drive, make sure that the
Configuration/Setup Utility has the startup
sequence set with diskette, CD ROM, and hard
disk drives.
001 - START
•
Power-off then power-on the system unit.
•
Run the Diagnostics program from the service
partition.
002 - DO ANY POST MESSAGES, ERROR
CODES, BEEPS, OR SYMPTOMS OCCUR? (YES,
READ AHEAD. NO, GO TO STEP 003)
•
Go to "Index of Symptoms, Messages, Error
Codes, or Beeps" on page 40.
•
End.
003 -
•
Select Utility from the menu.
•
Select and execute Tech Support Form from the
menu to generate a system configuration report.
•
Compare the system configuration list with the
actual devices installed in system.
NOTE: If necessary, remove the cover and visually
compare the devices installed in the system
unit to those shown in the Tech Support Form.
004 - IF THE NUMBER OF DISKETTE, HARD
DISK, OR CD-ROM DRIVE IS NOT CORRECT,
READ AHEAD; OR GO TO STEP 005.
•
Check the cable installation of all disk drives.(See
"System Board Jumpers and Connectors" on page
117)
- Diskette drive should be connected to the system
board connector FLOPPY.
- IDE Primary Channel Master and Slave Drives in
Configuration/Setup Utility should be connected
to the system board connector PRIMARY.
•
Check all power supply voltages, switch, and
jumper settings before you replace the system
board. (See "System Board Jumpers and
Connectors" on page 117)
Check Procedures 57