Olympus E-M1 Mark III Instruction Manual page 265

Highlight items using the FG buttons and press
5
the Q button.
• Options for the selected item will be displayed.
SSID
Authentication
Password
IP Address Assign
IP Address
Subnet Mask
Default Gateway
DNS
Highlight [Start Connection] using the FG buttons
6
and press the Q button.
7
If the camera is able to connect, the network will
be displayed with a check (v) next to the network
name.
• If the camera has been paired with more than one computer,
you will be prompted to choose a computer before the
network is displayed. Highlight the desired computer using
the FG buttons and press the Q button.
• The camera can be used only with the selected
computer. To select a different computer, you must fi rst
terminate the current connection.
• If the connection fails, the camera will display a
message to that effect, followed by the options shown in
Step 6. Repeat Steps 5–6.
Enter the network SSID.
Select the type of security used on the network. Choose from
[None] and [WPA2].
If you selected [WPA2] for [Authentication], enter the network
password.
Choose from [Auto(DHCP)] and [Manual]. Automatic IP address
assignment requires a network with a DHCP server confi gured to
supply IP addresses automatically.
These fi elds are required when [Manual] is selected for [IP
Address Assign].
w w Connect manually
100
%
SSID SSID_001
Authentication None
IP Address Assign Auto(DHCP)
Start Connection
Cancel
w w Connect manually
100
%
SSID SSID_001
Authentication None
IP Address Assign Auto(DHCP)
Start Connection
Cancel
Access Point Connection
w w
100
%
SSID_001
Connect by WPS
Connect manually
Close R/
w w
100
%
Connection failed
Set
5
Set
w
Set
EN 265