FWE R-AS-10 Installation Manual & Operating Instructions page 9

FWE MOBILE REFRIGERATED AIR SCREEN
CONTROL PANEL DESCRIPTION
(F) Temp Recall -
Press to display either
the "Actual Internal
Cabinet" or "Set Point"
temperature.
(A) On/Off Switch
Serves two functions, turns
cabinet ON or OFF and
also allows you to change
the temperature scale from
Degrees (F) Fahrenheit to
Degrees (C) Celsius
as required.
Every "event" or time the unit is used with the door open, the coil will build-up ice, reducing the
effectiveness of the overall operation of the unit. Defrost feature allows proper defrosting of the accumulated
condensation and ice build-up on the coil. Check water pan for a higher water level which indicates a
successful defrost of the coil. Certain conditions may require 3 repeated sequential defrosts.
(D) Temp Display -
Unit may display either "Actual Internal Cabinet" actual temperature, or desired "Set Point"
temperature in either Fahrenheit "dgF" (33°F to 38°F) or Celsius "dgC" (.56°C to 3.33°C) Scal
Actual: The factory default setting shows the actual internal cabinet temperature and acts as a digital thermomete
Set Point: To have temperature read-out display the "Set Point" temperature, press and hold the "Temp Recall"
button for five (5) seconds. The display will flash either "S" (Set), or "A" (Actual) to indicate which mode is active.
To switch back again, repeat this step holding the "Temp Recall" button for five (5) seconds.
To momentarily review the alternate display value, press and release the Temp Recall button.
-
(B) Power Indicator Light -
Indicates that the power is on.
(C) Cycling Indicator Light -
Indicates cabinet is cooling down.
-9-
(E) Temperature Setting -
TO CHANGE TEMPERATURE:
Press UP Arrow - or - DOWN Arrow.
Operating temperature is pre-set at
34°F (1.1°C) with temperature range
33°F to 38°F (.56°C to 3.33°C).