Assembly - Pride Mobility Victory Series Manual

V I I I . D I S A S S E M B L Y A N D A S S E M B L Y

ASSEMBLY

1. Push forward, then pull up on the manual freewheel
lever. Placing your Scooter in manual freewheel
mode may make it easier for you to maneuver the
rear section because the drive wheels are free to
turn.
2. Position the front and rear sections of your Scooter
as shown in figure 23.
3. Align the lower curved locking bracket slots on the
rear of the front section to the corresponding pegs
on the front of the rear section.
4. Gently push the front section toward the rear section
until the curved locking brackets are fully connected
onto the rear pegs.
5. Secure the front and rear frames with the locking
pin.
6. Place the cam lock levers in the locked (horizontal)
position. See figure 24.
7. Push down on the manual freewheel lever to engage the brake system.
8. If your Scooter is equipped with a handbrake, reconnect the handbrake cable by sliding the cable into its slot
on the brake mount. With your thumb, push forward and hold the brake release lever, then slide the cable
release hook onto the peg and gently let go of the brake release lever.
9. Raise the tiller to the desired, upright position by turning the tiller adjustment lever until it is loose. Verify the tiller
release buttons are reengaged and tighten the tiller adjustment lever.
10. Connect the large, white, 9-pin front-to-rear connector from the front section to the mating connector on the
rear section.
11. Place the batteries in the battery wells, then refasten the battery tie-down strap.
12. Connect the 2-pin battery harnesses into the mating harnesses that extend from the electronic controller module.
13. Gently place the rear shroud over the seat pedestal and slide it down into position. The reusable fasteners will
hold it in place.
14. Carefully lift the seat and slide the small seat post (on the bottom of the seat frame) into the seat pedestal.
15. Rotate the seat until it locks into place to complete the assembly of your Scooter.
Victory
LOCK CAM LOCK LEVERS
Figure 24. Lock Cam Lock Levers
33