Advertisement
Fit the catalytic panel to the side rack
1. Ensure the panels are placed the correct way
around:
in models with side lights: the cutout fits over the
light and the hole for the fixing screw goes to the
front of the oven.
in models with a ceiling light: the hole for
the fixing screw goes to the front of the oven.
Panels should sit flush
against the oven wall
2.
Fit the rear prongs of the side rack through the
holes in the catalytic panel.
Replace the side racks
1. Slide the rear prongs of the side rack into the holes at the rear of the oven
2. Fit the side rack front tab (and catalytic panel if fitted) over the fixing screw.
3. Replace the fixing nut. You may use a coin to tighten the nut.
https://producthelp.fisherpaykel.com/eu/Cook/Built-In_Ovens/Single/OB60SC9DEX1/User_Guide_OB60SC9DEX1/12_Care_...
Updated: Sat, 15 Feb 2020 09:47:27 GMT
Powered by
7
Advertisement
