Preparing For A Remote Configuration Of The G250 Via A Modem - Avaya G250 Quick Start For Hardware Installation

Hide thumbs Also See for G250:

Administration manual (840 pages)

Reference (812 pages)

Administration (720 pages)

Table Of Contents

Table of Contents

Prepare for Configuration

2. Connect the flat RJ-45 to RJ-45 cable to the DB-9 cable adapter.

3. Plug the RJ-45 cable into the G250 Console port.

4. Plug the DB-9 end of the cable into a COM port of the laptop.

5. At the prompt, enter username root and password root.

6. At the prompt, configure a new password.

7. At the prompt, enter y to configure basic gateway connectivity.

Note:

If you enter n but then change your mind, you can use the script-config CLI

Note:

command to run the installation script, so long as you have not saved any

configuration changes you may have made.

8. You are prompted to configure the following parameters. For each parameter, you can enter

a value, or press Enter to accept the default value shown in square brackets:

- VLAN number

- IP address for the primary management interface

- Subnet mask for the primary management interface

- IP address for the default gateway (router)

- Up to four IP addresses to specify the Media Gateway Controllers

- Hostname for the G250

9. The settings you configured are displayed, and you are prompted for confirmation.

If you confirm the settings, they are saved and the G250 reboots.

●

If you do not confirm the settings, you are prompted to re-configure them. If you enter y,

●

the parameters are presented again for configuration.

10. Connect the Ethernet port to the network to enable remote access to the gateway. A remote

technician can now further configure the gateway using the CLI.