Avaya G250 Quick Start For Hardware Installation page 29

2. On the Import EPW screen, import the Electronic Pre-Installation Worksheet (EPW) that
was prepared.
3. On the Usage Options screen, verify the role of this S8300 server.
4. Use the NVRAM Init screen to initialize the G250.
5. On the Date/Time screen, set the correct date, time, and time zone.
6. Click Continue in the Communication Manager Software Upgrade screen. You cannot use
the Avaya IW to upgrade Communication Manager software. Use the Software Update
Manager instead.
7. If you have a software update (patch) file for Communication Manager, use the Software
Update screen to select the file and update the software.
8. On the Phone Message Files screen, you can install standard and custom phone message
files.
9. On the Media Server - IP Addresses screen, enter IP information for the S8300.
10. If you selected the Install this media server as an LSP option in the Usage Options
screen, the LSP Controller screen appears. Enter the primary controller IP addresses for
registration and synchronization.
11. You can configure optional services: Uninterruptible Power Supply (UPS), Domain Name
Service (DNS), Network Time Protocol (NTP), or INADS remote support.
12. If you are not using IW to generate basic translations, select the Translation will be added
after the installation option on the Translation Source screen.
13. On the Security File screen, load the CM License file that you prepared from your laptop.
14. On the IP Addresses screen, click
a. To specify the details of the Primary Management Interface of the G250, use the PMI
screen.
b. To specify SNMP community strings and trap destinations, use the SNMP screens.
c. To specify the Media Gateway Controller(s) used to manage the G250 and the Transition
Point information, use the MGC List screen. Click Ping Test to test the accessibility of
each MGC.
15. On the Firmware screen, upgrade G250 and media module firmware. New firmware files
can be loaded from your laptop directly into the server /tftpboot directory, if needed.
16. Use the Change Master Key - Optional screen to optionally change the master key which is
used to encrypt gateway secrets (passwords, etc.) in the gateway configuration file.
17. If you have a service contract, the Gateway Authentication screen displays the installed
gateway Authentication file.
18. On the TFTP Server screen, configure the media gateway TFTP server capability to upload
IP Phone configuration files.
19. You can configure the modem in the modem configuration screens.
Preparing a G250 with an S8300 server
to configure the following information for the G250:
Issue 5 November 2009 29