Opc Ua Error Messages - Siemens SIMATIC RF650R Configuration Manual

Service and maintenance
12.2 Error messages
"ER" XML/ PLC block
LED LED (hex)
(hex)
-- 0x97 0xE7FE09
-- 0x7A 0xE7FE0A
"--" means that the error is not displayed by the LEDs.
12.2.3

OPC UA error messages

The following table lists the OPC UA-specific error codes.
Table 12- 3 OPC UA error messages of the RF600 readers
XML/ OPC UA AutoId
LED status status
(hex)
0x13 good 7
0x1A good 3
0x91 good 19
0x92 good 4
0x93 good 19
0x94 good 19
0x95 good 19
0x22 good 9
0xA1 good 8
0xA2 good 7
0xA3 good 19
0xA4 -- --
296
Error description
Command repetition is not supported.
Error during the transfer of the PDU (Protocol Data Unit).
AutoId
text
OUT_OF_RANGE_
ERROR
PERMISSON_
ERROR
RF_COMMUNICATION_
ERROR
PASSWORD_
ERROR
RF_COMMUNICATION_
ERROR
RF_COMMUNICATION_
ERROR
RF_COMMUNICATION_
ERROR
MULTIPLE_
IDENTIFIERS
NO_
IDENTIFIER
OUT_OF_
RANGE_ERROR
RF_COMMUNICATION_
ERROR
--
Error description
Address error
The address area of the transponder has been exceeded.
Possible causes:
Start address of the command start has been incor-
•
rectly set.
Wrong transponder type
•
The area to be written to is write-protected.
•
The transponder is read/write-protected.
The transponder is not responding.
The transponder password is incorrect. Access is denied.
The verification of the written transponder data has failed.
General transponder error
The transponder has too little power to execute the com-
mand.
More transponders are located in the transmission win-
dow than can be processed at the same time by the
reader.
There is no transponder with the required EPC-ID in the
transmission window or there is no transponder at all in
the antenna field.
The requested data is not available.
The transponder signals a CRC error.
The selected antenna is not enabled.
Configuration Manual, 03/2018, C79000-G8976-C386-06
SIMATIC RF650R/RF680R/RF685R