Handlebars And Display - Husqvarna Viking Platinum Q 165 User Manual

Handlebars and Display

U CAUTION: To prevent any electrical damage to the handlebars, always turn off all power to the
machine when connecting or disconnecting the handlebars.
To install the handlebars
1. Ensure that the machine is unplugged from the electrical outlet.
2. Locate the four screws and the 3 mm Hex tool.
Line up the holes on top of the handles with the
pre-drilled holes on top of the machine.
3. Slide a single screw into one of the holes until
it stops. Hand tighten the bolt enough to secure
the handles to the top of the machine. Insert
and hand-tighten the remaining two
handlebar bolts.
4. Use the included 3 mm Hex tool to securely
fasten the handles to the front of the machine.
5. After the bolts are in place, plug the cable into
the USB-style connection located on the front-
left side of the machine.
6. Remove the protective plastic from the touch-screen display before using.
To use the handlebar buttons
Press the Up/Down
button to cycle the
needle a half stitch.
14 |
powerquilter 1650 Quilting Machine User's Guide
UP SPEED
DOWN DOWN
Press the Speed Up or Speed Down buttons to change the 1.09"
stitches per minute setting (manual mode) or stitches per
inch (regulated mode).
SPEED START
1.09"
UP STOP
1.09"
Press the Start/Stop
button to start or stop
1.09"
the machine from
stitching.