Thread Mast - Husqvarna Viking Platinum Q 165 User Manual

Laser Focus and Image Size
Focus the laser by turning the threaded housing surrounding the lens clockwise or counterclockwise.
The laser image can be adjusted to project a bigger or smaller dot, or focal size. The direction of rotation
needed is determined by the distance of the laser from the pantograph surface. Experiment by rotating
the threaded end to achieve your desired focal size.
Laser Safety
When using the laser stylus, observe the following basic safety precautions.
• Never shine directly into the eyes.
• The laser stylus should never be left on and unattended.
• Do not use the laser stylus as a toy.
• Pay close attention when the laser stylus is being used by or near children or pets.
• Use the laser stylus only for its intended use as described in this manual.
 NOTE: If you can't see the threaded housing, the lens may be threaded too far into the laser body.
You will need to use a large slotted screwdriver to turn it counter clockwise until the housing is
visible. You can then rotate it with your fingertips to bring the light into focus. Be very careful to not
scratch the lens when using the screwdriver.
U CAUTION: Use of controls or adjustments or performance of procedures other than those specified
herein may result in hazardous radiation exposure.
Installing the Thread Stand
1. Locate the two threaded holes on the left side of the machine, near the top and towards the middle.
2. Remove the 2 screws. Line up the holes of the thread stand with the holes on the machine and reinsert the
screws.
3. Turn the thread stand until the eyelets are positioned over the spool pins.
 NOTE:
The eyelets of the thread stand MUST be centered over the spool pins. This ensures that the cone of
thread will not pull, turn or tilt, which will cause thread tension problems.
powerquilter 1650 Quilting Machine User's Guide
| 17