Switching Avaya Ix ™ Cu360 On Or Off - Avaya CU360 Installing And Administering

Initial setup and connectivity
• HDMI cable
• Power adaptor
• Rubber cap for camera
Procedure
1. Secure the Avaya IX
bottom of the endpoint.
2. Connect the HDMI cable in the HDMI ports of Avaya IX
3. Connect the power adaptor.
Switching Avaya IX
About this task
The power button of Avaya IX
• Switch Avaya IX
• Change the Avaya IX
mode.
Procedure
Do one of the following:
• To switch Avaya IX
• To change the mode of Avaya IX
mode, press the power button.
November 2019
™
CU360 endpoint on an external monitor using the hinge at the
™
CU360 on or off
™
CU360 on the rear of the device. You can use the power button to:
™
CU360 on or off.
™
CU360 mode to standby or wake up the device from the standby
™
CU360 on or off, press and hold the power button.
™
CU360 to standby or wake up the device from the standby
Installing and Administering Avaya IX Collaboration Unit CU360
Comments on this document? infodev@avaya.com
™
CU360 and the external monitor.
20