Remote Start Abort Message On The Instrument Cluster Display - If Equipped; To Enter Remote Start Mode; To Exit Remote Start Mode Without Driving The Vehicle; To Exit Remote Start Mode And Drive - Dodge CHARGER 2020 Owner's Manual

20 GETTING TO KNOW YOUR VEHICLE
WARNING!
Do not start or run an engine in a closed

garage or confined area. Exhaust gas
contains Carbon Monoxide (CO) which is
odorless and colorless. Carbon Monoxide is
poisonous and can cause serious injury or
death when inhaled.
Keep key fobs away from children. Opera-

tion of the Remote Start System, windows,
door locks or other controls could cause
serious injury or death.
Remote Start Abort Message On The
Instrument Cluster Display — If Equipped
The following messages will display in the
instrument cluster display if the vehicle fails to
remote start or exits remote start prematurely:
Remote Start Aborted — Door Open

Remote Start Aborted — Hood Open

Remote Start Aborted — Fuel Low

Remote Start Aborted — Trunk Open

Remote Start Disabled — Start Vehicle To

Reset
The message will stay active until the ignition is
placed in the ON/RUN position.

To Enter Remote Start Mode

Push and release the remote start button on the
key fob twice within five seconds. The vehicle
doors will lock, the parking lights will flash, and
the horn will chirp twice (if programmed). Then,
the engine will start, and the vehicle will remain
in the Remote Start mode for a 15 minute cycle.
NOTE:
If an engine fault is present or fuel level is

low, the vehicle will start and then shut down
in 10 seconds.
The parking lights will turn on and remain on

during Remote Start mode.
For security, power window and power

sunroof operation (if equipped) are disabled
when the vehicle is in the Remote Start
mode.
The engine can be started two consecutive

times with the key fob. However, the ignition
must be cycled by pushing the START/STOP
ignition button twice (or the ignition switch
must be placed in the ON/RUN position)
before you can repeat the start sequence for
a third cycle.
To Exit Remote Start Mode Without Driving

The Vehicle

Push and release the remote start button one
time or allow the engine to run for the entire
15 minute cycle.
NOTE:
To avoid unintentional shutdowns, the system
will disable for two seconds after receiving a
valid remote start request.
To Exit Remote Start Mode And Drive The
Vehicle
Before the end of 15 minute cycle, push and
release the unlock button on the key fob to
unlock the doors and disarm the vehicle
security alarm (if equipped). Then, prior to the
end of the 15 minute cycle, push and release
the START/STOP ignition button.