Daytime Running Lights (Drls) - If Equipped; High/Low Beam Switch; Automatic High Beam - If Equipped - Dodge CHARGER 2020 Owner's Manual

44 GETTING TO KNOW YOUR VEHICLE
Multifunction Lever
Daytime Running Lights (DRLs) — If
Equipped
The Daytime Running Lights will turn on when
the engine is started and will remain on unless
the headlamps are turned to the on position,
the parking brake is applied, or the ignition is
placed in the OFF position.
NOTE:
If allowed by law in the country in which the
vehicle was purchased, the Daytime Running
Lights can be turned on and off using the Ucon-
nect System, refer to "Uconnect Settings" in
"Multimedia" for further information.

High/Low Beam Switch

Push the multifunction lever away from you to
switch the headlights to high beam. Pull the
multifunction lever toward you to switch the
headlights back to low beam.
Automatic High Beam — If Equipped
The Automatic High Beam Headlamp Control
system provides increased forward lighting at
night by automating high beam control through
the use of a digital camera mounted on the
windshield. This camera detects vehicle
specific light and automatically switches from
high beams to low beams until the approaching
vehicle is out of view.
NOTE:
The Automatic High Beam Headlamp Control

can be turned on or off by selecting "ON"
under "Auto High Beam" within your Ucon-
nect settings, as well as turning the headlight
switch to the AUTO position. Refer to "Ucon-
nect Settings" in "Multimedia" for further
information.
Broken, muddy, or obstructed headlights and

taillights of vehicles in the field of view will
cause headlights to remain on longer (closer
to the vehicle). Also, dirt, film, and other
obstructions on the windshield or camera
lens will cause the system to function improp-
erly.
If the windshield or Automatic High Beam
Headlamp Control camera is replaced, the
camera must be re-aimed to ensure proper
performance. See a local authorized dealer.
To Activate
1. Turn the headlight switch to the AUTO
headlight position.
2. Push the multifunction lever away from you
(toward front of vehicle) to engage the high
beam mode.
NOTE:
This system will not activate until the vehicle is
at or above 15 mph (24 km/h).