Display And Acknowledge Events, If Necessary - Bosch BT220 Technical And Operations Manual

BT220 Technical Information and Operation
Operation
5.1

Display and Acknowledge Events, if necessary

5-2
Display
Fault
Warning
Message
Fig. 5-2:
After it is switched on the BT220 is in Message Display Mode. All events
which are transmitted by the connected weld timers can be displayed and
acknowledged, if necessary.
If no event has occurred, the text "No message" is shown in the display (see
Figure).
Whole display text flashes:
Display text does not flash:
Fault (red LED flashes):
Warning (yellow LED flashes): A warning is present.
Message (green LED):
Acknowledge key
Front View BT220
An event is present and must be acknowl-
edged with the key
Call up Help on the event:
Close Help:
An event which does not have to be ac-
knowledged or has already been acknowl-
edged (is logically TRUE) is present. As
soon as the event is no longer present, the
corresponding display text is automatically
deleted.
Call up Help on the event:
Close Help:
Fault/error message is present.
' Remedy fault and acknowledge with
' Remedy the cause and acknowledge
with
There is more than 1 event present.
You can select the event automatically dis-
played by the BT220 (see page 5-24).
Other events present can be found in the
message memory (max. 100) and dis-
played with the cursor keys A and ".
You can find additional information on the
message memory on page 5-17.
Help key
Cursor keys
.
Key i
Key i
Key i
Key i
.
1070 080 037-101 (99.01) GB
.