Using A Wired Remote Control - Panasonic PT-D10000U Service Manual

7 Using a Wired Remote Control

7.1. Connection Example
When multiple main units are connected as part of the system, connect to units with a M3 stereo mini jack cable (sold separately)
to simultaneously control multiple main units with a single remote control through the REMOTE1 IN/OUT terminal. It is effective to
use the wired remote control in the environment in which an obstacle stands in the light path or where devices are susceptible to
outside light.
· Use a two-wire shielded cable with a length of 15 m or less. If the length of the cable exceeds 15 m, the shielding of the cable
may not be sufficient and the remote control may not work.
7.2. Setting Projector ID Number to Remote Control
Every projector has its ID number and the ID number of the controlling projector must be set to the remote control in advance so
that the user can operate the remote control. The ID number of the projector is set to "ALL" on shipping, and use the ID ALL button
of the remote control when using only a single projector.
Procedure of ID setting
Press ID SET, and then within 5 seconds, press the two numeric (0-9) buttons which correspond to the ID number that has been
set for the projector.
· The main unit has its ID number (1-64 or ALL), and set to remote control when the ID number is 1-9 as 01-09. When the
ID number is "ALL", set it with the ID ALL button of the remote control unit.
· Do not press the ID SET button accidentally or carelessly because the ID number on the Remote Control can be set even
when no projector is around.
· If you do not enter the two-digit ID number within 5 seconds after the ID SET button has been pressed, the ID number will
remain at the number that was set before the ID SET button was pressed.
· Your specified ID number is stored in the remote control unit unless another one is specified later. However, the stored ID
will be erased if the batteries of the remote control are left exhausted. When the batteries are replaced, set the same ID
number again.
21
PT-D10000U / PT-D10000E / PT-DW10000U / PT-DW10000E