Using A Wired Remote Control; Connection Example; Setting The Projector Id Number For Remote Control - Panasonic DLP PT-D5500U Service Manual

PT-D5500U / PT-D5500E / PT-D5500UL / PT-D5500EL

6 Using a Wired Remote Control

6.1.

Connection Example

When two or more projectors are connected in the system, connect the projectors with the supplied remote control cable to
simultaneously control the projectors with a remote control unit through the REMOTE1 IN/OUT terminal. It is effective to use the
wired remote control in the environment in which an obstacle stands in the light path or where the system is susceptible to outside
light.
6.2.

Setting the Projector ID Number for Remote Control

Every projector has its ID number and the ID number of the controlling projector must be set to the remote control in advance so
that the user can operate the remote control. The ID number of the projector is set to "ALL" on shipping, and use the ID ALL button
of the remote control when using only a single projector.
Procedure of ID setting
1. Change the position of the operation mode selector awitch to "Computer".
2. Press the ID SET button, and within five seconds use the number (0 to 9) buttons to enter the 2-digit ID number set by the
projector.
3. Change the position of the operation mode selector switch to "Projector".
However, if the ID ALL button is pressed, the projector can be controlled regardless of the ID number of the projector
(simultaneous control mode).
· Do not press the ID SET button accidentally or carelessly because the ID number on the remote control can be set even
when no projector is around.
If the ID SET button is pressed, the ID number goes back to the one set before pressing the ID SET button unless a
numeric button is pressed within five seconds after the ID SET button is pressed.
· Your specified ID number is stored in the remote control unit unless another one is specified later. However, the stored
ID will be erased if the batteries of the remote control are left exhausted. When the dry cells are replaced, set the same
ID number again.
20