Lexus RX350 Manual page 135

• The driver's seat belt has been
unfastened.
When any of the following has been
performed, the seat and steering
wheel automatically return to their
original positions.
• The engine switch has been turned
to ACCESSORY mode or IGNI-
TION ON mode.
• The driver's seat belt has been fas-
tened.
■ Operation of the power easy access sys-
tem
When exiting the vehicle, the power easy
access system may not operate if the seat is
already close to the rearmost position, etc.
■ Customization
Some functions can be customized.
(P.470)
Recording a driving position into
memory
1
Check that the shift lever is in P.
2
Turn the engine switch to IGNI-
TION ON mode.
3
Adjust the driver's seat, steering
wheel, outside rear view mirrors
and head-up display (if equipped)
to the desired positions.
4
While pressing the "SET" button, or
within 3 seconds after the "SET"
button is pressed, press button "1",
"2" or "3" until the buzzer sounds.
If the selected button has already been
preset, the previously recorded position
3-3. Adjusting the seats
will be overwritten.
■ Seat positions that can be memorized
(P.122)
The adjusted positions other than the posi-
tion adjusted by lumbar support switch can
be recorded.
In order to correctly use the driving
■
position memory function
If a seat position is already in the furthest
possible position and the seat is operated in
the same direction, the recorded position
may be slightly different when it is recalled.
WARNING
■ Seat adjustment caution
Take care during seat adjustment so that
the seat does not strike the rear passen-
ger or squeeze your body against the
steering wheel.
Recalling a driving position
1
Check that the shift lever is in P.
2
Turn the engine switch to IGNI-
TION ON mode.
135
3