Table of Contents
Advertisement
fhf0mstr.book Page 2 Tuesday, April 20, 1999 10:39 AM
April 20, 1999 10:38 am
Executing Windows 95, 98, and NT
Diagnostic Program
1. Verify that the EtherJet CardBus Ready Port Adapter with
Modem has been installed and configured to work in your
version of Windows.
2. Insert the IBM CD-ROM.
3. Select Start Run. Type path/EJETDIAG.EXE, where path/
is the drive containing the IBM CD-ROM.
4. Navigate through the diagnostic program by selecting the
appropriate tab. When finished, click OK to exit.
Executing the MS-DOS/Windows 3.x
Diagnostic Program
IBMCTEST can only be run from the MS-DOS command line. It
cannot be run from a DOS box within Windows.
Note:
Do not run IBMCTEST with a network driver loaded.
Loading a network driver before running IBMCTEST may
cause unpredictable results when exiting the test utility.
1. Install the EtherJet CardBus Ready Port Adapter with Modem
according to the instructions contained in Chapter 1,
"Hardware Installation."
2. Power down and restart the computer from MS-DOS. Do not
load a network driver.
3. Run the diagnostic test by typing path/IBMCTEST at the
MS-DOS prompt, where path/ is the drive containing the IBM
CD-ROM, then press Enter.
Main Panel
The panel consists of several function buttons and a view
window. Pressing or invoking a function will bring up the
corresponding in the view window. This view remains until
another is selected. To exit IBMCTEST type x or select the Exit
button.
4-2 EtherJet CardBus Ready Port Adapter with Modem
Advertisement
Table of Contents
Troubleshooting
