Table of Contents
Advertisement
fhf0mstr.book Page 3 Tuesday, April 20, 1999 10:39 AM
April 20, 1999 10:38 am
How to Create Diskettes for Software
Installation
To create a set of diskettes for use in installation, as an
alternative to using the IBM CD-ROM, run MAKEDISK.BAT from
the IBM CD-ROM to copy the required installation files to two
blank diskettes.
Installing the EtherJet CardBus Ready Port
Adapter with Modem
1. With Windows running, insert the EtherJet CardBus Ready
Port Adapter with Modem into the CardBus PC Card slot and
connect cables as shown in Chapter 1, "Hardware
Installation."
2. When Windows displays the New Hardware Found window,
type the path to the IBM CD-ROM and follow the instructions
on the screen to complete the installation.
IBM files will be copied from the IBM CD-ROM and network
and modem functionality will be installed. If you are prompted
again for network drivers, type the path to the IBM CD-ROM
and select OK.
Note:
If you are using Windows 95 and the New Hardware
Found window does not appear, you are probably using
Windows 95 Version 950 or 950a. Windows 95 Version
950 or 950a are not supported with the EtherJet CardBus
Ready Port Adapter with Modem due to limitations for
CardBus malfunction (LAN and Modem) devices.
3. After installation, select No if you are prompted to reboot.
4. Select Start Run. Type path/SETUP.EXE, where path/ is
the drive containing the IBM CD-ROM. IBM utilities and
online documentation will be installed in a program group on
your hard drive.
5. When you are prompted to reboot, select Yes. After the
computer restarts and Windows reloads, IBM CountrySelect
will launch. Make a country selection (U.S.A. is the default).
Chapter 2. Windows 95 and Windows 98 Installation 2-3
Advertisement
Table of Contents
Troubleshooting
