Control Boards - ABB ACA 6 Series Hardware Manual

Control Boards

Control Board Diagram
(R4i to R7i)
ACS 600 MultiDrive Hardware Manual
One phase module block includes the following boards:
• main circuit interface board (NINT): This board gives the control
commands and sends measurement signals.
• two control distribution boards (NXPP, in frame size R10i and up).
These boards distribute the control commands given by the NINT
board.
• gate driver boards (NGDR), in frame size R4i and up. These boards
amplify the control pulses for the insulated gate bipolar transistors
(IGBTs).
• power supply board for gate drivers (NGPS) in V-phase module
• power supply board (NPOW-62) in V-phase module. This board is
not included in frame sizes R2i and R3i.
• main circuit board NBUB in frame size R3i
An inverter of frame size 2 x R12i includes twice the control boards of
an R12i inverter. An inverter of frame size 3 x R12i includes three times
the control boards of an R12i inverter, etc.
This diagram shows the control boards that control an inverter of size
R4i to R7i.
Power plate
NDCU
NAMC
NINT
Two NGDR boards
control one power
plate
U, V, W
Chapter 1 – Introduction
1-5