Siemens FN2012-A1 Mounting & Installation page 31

Switch position
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
Building Technologies
Siemens Industry, Inc.
Rotary switch for device configuration
Configuration via the rotary switch is required for an Ethernet switch that is not
integrated into a panel. As an integrated Ethernet switch, the rotary switch must be
set to '0'.
By using the rotary switch for device configuration, the Ethernet switch can be set to
predefined network addresses or operation modes.
To accept a new configuration, the switch must be in a de-energized state when the
setting is made or a hardware reset must be performed afterward.
IP address/operating mode
Configured via web interface or MoNet
bus
Factory setting: 0.0.0.0
192.168.99.241
192.168.99.242
192.168.99.243
192.168.99.244
192.168.99.245
192.168.99.246
192.168.99.247
192.168.99.248
192.168.99.249
192.168.99.250
192.168.99.251
192.168.99.252
Reserved (0.0.0.0)
Repeater mode
192.168.200.4
Adjustment elements
Sub-net mask/operating mode
Configured via web interface or MoNet
bus
Factory setting: 255.255.248.0
255.255.248.0
255.255.248.0
255.255.248.0
255.255.248.0
255.255.248.0
255.255.248.0
255.255.248.0
255.255.248.0
255.255.248.0
255.255.248.0
255.255.248.0
255.255.248.0
Reserved (255.255.255.255)
Repeater mode
255.255.255.0
8
31 | 34
A6V10407862_d_en_--
2018-09-07