ADC ADView 2 User Manual page 23

Averaging Measurement Mode
Select Mode
Press the Mode Toggle Button
until you see the
Averaging Measurement Mode
Icon . . From single
measurement mode, that will only
be one button press.
Example of Averaging
Measurement Mode setup screen
with default values.
*Note: In averaging mode, you are unable to see individual readings. Averaged Results will be displayed at the end of
all the readings. By default, all measurements taken (from 2 to 5) will be included in the averaging calculation. Using
the Advanced Configuration Application, the device can be programmed to always throw out the first measurement
taken and not include it in the averaging calculation.
**Note: All values selected during the Averaging Measurement Mode will be displayed the next time that this mode is
used, so that the same customized averaging protocol can be set and used each time that Averaging Measurement
Mode is used.
93-9005-00
September 1, 2016
Set # of Measurements to Average
The Number of Measurements Icon
will flash as will the Selection
Knob. To keep the default of 3
measurements, press Knob. Or turn
Knob to choose a different number
and press Knob to select.
You can select 2 to 5 measurements
to average*. In this example, 4
measurements are set to be
averaged.
Set Time Between Measurements
Default values for Time Before First
Measurement and Time
Between Measurements
flash in sequence as the user is
prompted to set each value. To keep
defaults, press Knob. Or turn Knob to
choose new values and press Knob
to select.
On left is Time Before First Reading
will start. Select 0-5 min. Default = 0.
On right is Time Between
Measurements. Select 15-120 sec.
Default = 15 sec.
ADView 2 User Manual | 23
will