Mitsubishi MELDAS HS Series Specifications And Instruction Manual page 118

No. Name
Initial absolute position
93
fluctuation
Detector, multi-rotation
9E
counter error
9F Battery voltage drop
E0 Over-regeneration warning
E1 Overload warning
Absolute position counter
E3
warning
E4 Parameter error warning
E7 CNC emergency stop
Instantaneous stop
E9
warning
• Deceleration method
Deceleration control
Dynamic
∗
• Reset method
NR
PR
AR
Chapter 10 Troubleshooting
Deceleration method Reset method
The motor will not stop.
Deceleration control
The motor will not stop.
: The motor will be decelerated and controlled with the time constant set in the parameter (EMGt).
If dynamic brake stop is selected with the parameter (SPEC), the motor will stop with the dynamic
brakes.
: The motor will stop with the dynamic brakes.
: The unit will be automatically reset when the state in which the warning occurred is canceled.
: Reset with the CNC reset button. Resetting is also possible with the PR, AR resetting conditions.
: Reset by turning the CNC power ON again. Resetting is also possible with the AR resetting conditions.
: Reset by turning the servo amplifier power ON again.
PR
∗
∗
∗
∗
∗
∗
∗
When the instantaneous warning occur, use NR reset. The
NR
state will also be reset automatically after 5 minutes.
10–9
Explanation