Combination Switch
1
Low beam (with exterior lamp
switch turned to position
2
High beam (with exterior lamp
switch turned to position = £ > )
3
High beam flasher (high beam
available independent of exterior
lamp switch position)
4
Turn signals, right
5
Turn signals, left
To operate the turn signals, move the
combination switch past the point of
resistance (up or down). The switch is
automatically canceled when the
steering wheel is turned to a large
enough degree.
46
To signal minor directional changes,
such as changing lanes on a highway,
move combination switch to the point
)
of resistance only and hold it there.
6
Control for
•
windshield washer system
•
headlamp cleaning system (will
work only with exterior lamp
switch in position
Canada only:
Also in position O when the
engine is running).
When the washer system is
activated, the wipers also operate
for a limited time.
The reservoir, hoses, and nozzles
of the windshield washer and
headlamp cleaning systems are
automatically heated.
7
Windshield wiper control
0
Wiper off
1
Intermittent wiping
II
Normal wiper speed
III Fast wiper speed
Note:
If one of the turn signals fails, the turn
signal indicator system flashes and
sounds at a faster rate than normal. In
addition, the lamp failure indicator will
come on.
If the windshield wipers smear the
windshield, even during rain, activate
the washer system as often as neces
sary. The fluid in the washer reservoir
should be mixed in the correct ratio.
For the overload protection of the
windshield wiper motor, see page 84.
Mixing ratio
For temperatures above freezing:
MB Windshield Washer Concentrate
^00^
ID
or
"S" and water
1 part "S" to 100 parts water
(40 ml "S" to 1 gallon water).
For temperatures below freezing:
MB Windshield Washer Concen
trate "S" and commercially available
premixed windshield washer solvent/
antifreeze
1 part "S" to 100 parts solvent
(40 ml "S" to 1 gallon solvent).