Mercedes-Benz 350 SDL Owner's Manual page 88

Towing the Vehicle
The front towing eye is located on the
passenger side behind a flap in the
bumper panel. The rear towing eye is
located at the right below the bumper.
Flap removal: Insert finger in recess of
flap and pull flap out.
Flap installation: Engage flap at
bottom and press top in securely.
86
We recommend that the vehicle be
transported using flat bed equipment.
This method is preferable to other
types of towing.
The vehicle may be towed with all
wheels on the ground and the selector
lever in position "N" for distances up
to 120 km (75 miles) and at a speed
not to exceed 50 km/h (30 mph).
To positively avoid a possibility of
damage to the transmission, however,
we recommend to disconnect the
drive shaft at the rear axle drive flange
on any towing beyond a short tow to a
nearby garage.
Do not tow with sling-type equipment.
Towing with sling-type equipment over
bumpy roads will damage radiator and
supports.
Use wheel lift or flat bed equipment.
Note:
With the engine not running, there is
no power assistance for the braking
and steering systems. In this case, it
is important to keep in mind that a
considerably higher degree of effort is
necessary to brake and steer the
vehicle.
Jump Starting
If the battery is discharged the engine
can be started with jumper cables and
the (12V) battery of another vehicle.
Warning!
Failure to follow these directions
can lead to a battery explosion
and personal injury.
Read all instructions before pro­
ceeding.
Proceed as follows:
1. Position the vehicle with the
charged battery so that the jumper
cables will reach, but never let the
vehicles touch. Make sure the
jumper cables do not have loose
or missing insulation.
2. On both vehicles:
• Turn off engine and all lights
and accessories, except
hazard flashers or work lights.
• Apply parking brake and shift
selector lever to position "P".
• Be sure the battery vent caps
are tight. Place a damp cloth
over the vent caps, making
certain it is clear of all moving
parts.