Siemens SINAMICS S120 Faq page 14

SINAMICS S120 at Technology CPU Entry ID: 21767896
Table 3-2 Configuration of the hardware components in HW Config
No.
1.
2.
3.
4.
5.
V1.0
Connection Establishment to SINAMICS S120
Instruction
Edition 10/28/05
Requirements
Note
In the STEP 7 project, open the
HW Config configuration tool.
In the module catalog, select the
SIMATIC Technology-CPU profile
and insert a Rack, optionally a
power supply and explicitly a
Technology CPU into your project.
Acknowledge the message on the
baud rate by clicking OK.
Address 2 is assigned to the CPU.
Create a new DP(Drive) subnet
using the New button.
Set a transmission rate of
12 MBaud for the DP(Drive) and set
the DP profile.
Subsequently select further settings
for the DP(Drive) using the
Options... button.
14/58