Invacare Medley Ergo Soft Tilt User Manual page 9

3.
Connect the cables of the right and left motor to the two extension
cables and from the control box. The right motor cable is
S T
marked on the cable clip corresponding to
1
the control box and the left motor cable is marked
clip corresponding to on the control box cable. Deactivate the
2
emergency stop, turn the system on, activate manual mode and use
the hand control to check that the left and right motor are correctly
connected to the control box (see chapter Usage for detailed
instructions).
Ensure that all cables run underneath the bed frame tubes and
move the bed all the way up and down to ensure no cables
are getting squeezed.
4.
Collect all the cables in a bundle and tighten it with a zip tie, move
the bed up and down to make sure that the bundle is not clinging
on any bed parts and moves freely.
Mounting the arms and cover
1. Ensure both wings of the main module are slightly elevated, so
the connections for the arms are accessible.
2.
Connect the four arms with the main module, following the
representation on the arms label shown in the zoomed image U,
the black shaded area on the sticker represents the location were
the arm must be placed. Fix the four arms with the Allen bolts from
set  and tighten the lock nuts facing inwards. Ensure the safety
washers are placed on the lock nut side.
IVCMAMED221119
on the cable from
1
on the cable
2
3.
Ensure that the head arms is mounted on the telescopic bracket V
in the fifth threaded hole and you are able to see the remaining 4
threaded holes. For the foot arms make sure the telescopic bracket
W, is mounted fully in and you are not able to see any free holes.
4.
IMPORTANT!
Before usage, adjust, with the patient weight into account,
the position of the four arms for optimal lifting support.
Ensure that the four arms still go in a horizontal position in
flat mode.
To adjust the position of the arms adjust the bolt X until the arms are
in a horizontal position.
5.
Mount the cover by sliding the pockets over the head end and
foot end arms. The head end of the cover contains the label
information and placement of the cover symbol:
Symbol indicating the head end of the cover.
Setup
9