Diode Installation; System Features; Additional Information - Gemini My TRACK 955MyBasic Installer Manual

11.0 - DIODE INSTALLATION

How to tell if you need to install a diode:
!
Activate one of the turn indicators, turn ignition OFF and arm the alarm.
f
!
If the instrument panel lights up when the turn indicators are activated, a
diode needs to be installed (follow diagram below).
Vehicle wiring harness
Before
Turn indicator relay
Cut
Live feed
to indicator
PAGE 12
After
Turn indicator relay
Diode inserted
in vehicle
wiring harness
Vehicle original
wiring

12.0 - SYSTEM FEATURES

AVAILABLE FEATURES
System arming by remote control
System disarming by remote control
Arming optic signals
Disarming optical signals
Pre-alarm optical signals (15")
Engine immobilizer (8A load , with system armed) remotely activatable by user
Negative additional output (external relay and siren)

13.0 - ADDITIONAL INFORMATION

Care should be taken to protect the electronic tracking device:
!
The unit must be installed away from heat sources and potential water
infiltrations.
!
Do not use voltages other than the one specified by the manufacturer.
!
D o not clean the unit with water but use a damp cloth to wipe.
!
Do not remove warranty labels.
! Protect the alarm unit from any direct water flow such as high-powered
water jets found in a car wash.
GEMINI TECHNOLOGIES WILL NOT BE HELD RESPONSIBLE FOR
ANY DAMAGE CAUSED BY IMPROPER USE OR INSTALLATION.
PAGE 13