Alarm Unit Positioning; Accessories Positioning; Status Led; Contact Switch (Optional) - Gemini My TRACK 955MyBasic Installer Manual

4.0 - ALARM UNIT POSITIONING

Do not install the alarm unit in this
position because water may infiltrate
NO!
permanently damage the electronic
circuit making the alarm system
Eventual malfunctioning due to
water infiltration is not covered by
!
Installing th e control unit
water entering the unit
!
It is important to give the rubber sheath a 'goose-
neck' bending as shown in the picture opposite and
secure with a tie wrap.
!
The control unit must not be exposed to atmospheric
agents .
!
The control unit
OK!
mechanical parts, electric or electronic components
that could generate high frequency electromagnetic
disturbances and away from devices that could
reach high temperatures when the vehicle is in use.
!
The control unit
vehicle frame.
ATTENTION
Make sure the GPS antenna side is facing away from the vehicle
frame. It is essential that the antenna has a "sky view".
The GPS antenna is built in the part of the tracker casing opposite
the Gemini label (see Fig.1).
PAGE 4
trough the rubber cap and
unreliable.
warranty.
in this position, will prevent
.
must be installed away from moving
must not be installed directly on the
ALARM POSITIONING FOR MAXIMUM PERFORMANCE
Whichever way the tracker is positioned, make sure the GPS antenna side
is facing away from the vehicle frame.
For best performance, it is essential that the antenna has a "sky view".
Gemini label must face the vehicle frame.
The following other positions are also considered acceptable but the GPS
performance is reduced.

5.0 - ACCESSORIES POSITIONING

5.1 - STATUS LED

The LED must be installed where it can readily be seen because it serves as
both a system status indicator and a visual theft deterrent.
Use a 10mm drill bit.

5.2 - CONTACT SWITCH (OPTIONAL)

A contact switch can be fitted to protect the seat or topcase. It must be installed
in such a way as to detect the opening of the seat/topcase without being
accessible from the outside. The trigger threshold must be carefully set to
avoid false alarms.
A negative trigger input will generate an alarm.
NB: If no contact switch is fitted, the GREEN/BROWN wire will remain free for
other possible uses.
PAGE 5