Philips SBCSC477/05 Instructions For Use Manual page 7

Mains operated use / charging the battery pack
1 Remove the battery compartment cover (9).
Push on the round part, keep it down and slide the cover downwards.
2 Insert the battery pack (without the battery pack, the unit might not work
correctly):
Plug the connector of the cable into the connector on the left side of the
battery compartment.
Place the side with the connection cable in the top of the battery
compartment.
3 Put the battery compartment cover back in place. Put the cover on the
compartment and slide the cover upwards until it clicks.
If the rechargable battery pack begins to lose its effectiveness, replace it with
a new battery pack. Use rechargeable NiMH battery packs only!
4 Connect the AC power adapter (24) to a mains socket and the cord to
the DC power supply socket (23) of the charging base.
5 Place the Parent Unit inside the charging base.
POWER
The red charging light (22) lights.
CHARGE
The Parent Unit can be operated now, but you should leave it in the
charging base until the battery pack is fully charged (at least 14 hours).
When the battery pack is fully charged, the Parent Unit can be taken out of
the charging base and used cordlessly for up to 16 hours.
When the battery check light (13) flashes red, the battery power is low.
Place the Parent Unit inside the charging base to recharge the battery pack.
Note: Never operate the Parent Unit without a battery pack!
Disposal of batteries
Dispose of used batteries in an environmentally friendly manner.
Do not mix old and new batteries, or different types of batteries.
Remove Baby Unit batteries if the baby monitor is not to be used for
long periods.
Without the battery pack, the unit might not work correctly
ENGLISH
7