Getting The Baby Monitor Ready; Baby Unit; Parent Unit - Philips SBCSC477/05 Instructions For Use Manual

ENGLISH
6

Getting the baby monitor ready

Baby Unit

For your convenience the Baby Unit can be mains or battery operated.
Mains operated use
1 Connect the AC power adapter (11) to a mains socket and the cord to
the DC power supply socket (10) of the Baby Unit.
2 The Baby Unit is now ready for mains operated use.
Battery operated use
1 Remove the battery compartment cover (9).
Push on the round part, keep it down and slide the cover downwards.
2 Insert four 1.5V, LR6 (AA) Alkaline batteries noting the + and -
configuration inside the battery compartment.
(The batteries are not included; we recommend non-rechargeable Philips
Alkaline batteries).
3 Put the battery compartment cover back in place. Put the cover on the
compartment and slide the cover upwards until it clicks.
4 The Baby Unit is now ready for battery operated use.
The Baby Unit operates for up to 30 hours on fresh batteries
(Philips Alkaline batteries, Baby night light switched off).
5 When the battery check light (4) flashes red, the battery power is low.
Install new batteries if this happens.
Tips:
– Switch off the Baby night light to save battery power, when the Baby Unit is
battery operated.
– Remove empty batteries from the Baby Unit.
Battery back-up
As soon as the batteries are inserted battery back-up will be activated. In
case of mains failure during mains operated use the unit will automatically
switch to battery operated use. As soon as the mains supply is back on
the unit switches to mains operated use again.

Parent Unit

The Parent Unit comes with and uses high performance rechargeable
battery pack.The battery pack must first be inserted and charged before
the Parent Unit can be used outside the charging base (21).
Note: Never operate the Parent Unit without a battery pack!
Without the battery pack, the unit might not work correctly.