Non-Adjustable Non-Assembled Roof Curb Installation - Lennox FLEXY II Series Installation, Operating And Maintenance

INSTALLATION ON A ROOF MOUNTING FRAME
NON ADJ USTABLE NON ASSEMBLIED ROOFCURB INSTALLATION
FRAME P ARTS IDENTIFICATION
Figure 8 shows the different parts used in the assembly of this roof mounting f rame.
INSTALLATION
The roof mounting frame prov ides support when the units are installed in down-f low configurations.
The non adjustable, non assembled roof mounting f rame can be installed directly on decks having adequate structural strength
or on roof supports under deck.
NOTE: frame assembly must be installed f lat, lev eled within 5mm per linear meter in any direction
IOM – FLEXY II – 1007 – E
UNIT FLOOR
UNIT FLOOR
INSULATION
AIR DUCT
Fig. 8
UNIT Support rail
ROOFCURB
Page 20