Installation On Roof Mounting Frame - Lennox FLEXY II Series Installation, Operating And Maintenance

INSTALLATION ON A ROOFMOUNTING FRAME
CAUT ION:
-
An approach ramp must be installed if the unit's installation requirements tell that it's
necessary to reach the main switch. This recommendation is valid for installations in
general and in particular for return and curbs. It's also valid to reach other parts of
the unit: filters, refrigerant circuit, etc...
-
It's advised to fix curbs and roofcurbs to the unit.
As lev els are adjustable, observe the following
recommendations when installing the equipment
Abov e all, ensure that all the adjustable returns are facing
outward ("1" f igure 4). They are usually turned inside-out
f or transport.
Place the roof mounting f rame on the trimmer beam by
f irst lining up the inlet and the outlet
After lev elling the f rame, secure the adjustable returns on
the trimmer.
It is important to centre the unit on the roof frame
IOM – FLEXY II – 1007 – E
opening. ("2"- figure 5)
Fig. 4

Fig. 5
Fig. 6
Page 17