Accessories; Part Names And Functions - Panasonic ET-MDNFB10 Operating Instructions Manual

Accessories

Make sure that the following accessories are provided with the product. Numbers enclosed in < > show the
number of accessories.
Port cover <2>
(DVHR1128ZA/X1)
(Attached to the product at the time of purchase)
Attention
f After unpacking the product, discard the packaging material properly.
f For missing accessories, consult your dealer.
f Store small parts in an appropriate manner, and keep them away from small children.
Note
f Supplied screws are spare parts. Use them when the screws to fix the slot cover of the projector are lost.
f The model numbers of accessories are subject to change without prior notice.

Part names and functions

1 SFP port 1
This is the port to install the SFP module for receiving.
2 SFP port 2
This is the port to install the SFP module for sending and
receiving.
Note
f The sending function of the SFP module for sending or for sending and receiving will not operate when it is installed in the
SFP port 1.
f In addition to the SFP module for sending and receiving, the SFP module for receiving or for sending can be installed in the
SFP port 2.
rWhen the SFP modules are installed
This is an example when the SFP module for receiving (LC connector) is installed in the SFP port 1, and the SFP
module for sending and receiving (LC connector) is installed in the SFP port 2.
1 <SDI OPT 1 IN> terminal/<SDI OPT 2 IN> terminal
These are terminals to input SDI signal (optical signal).
Note
f The input signal to the <SDI OPT 1 IN> terminal or the <SDI OPT 2 IN> terminal that is selected for input is output from the
<SDI OPT 1/2 OUT> terminal.
Precautions for use
Screw <4>
(XSB3+8FN)
4 1 2 3
3
4
1 1 2
2
4
Input indicator <SIGNAL>
This is the indicator to indicate the detection state of the video
signal. This is illuminated when input of the video signal is
detected in either or both of the <SDI OPT 1 IN> terminal and
the <SDI OPT 2 IN> terminal.
Handle
<SDI OPT 1/2 OUT> terminal
This is an active through terminal to output the signal input to
the <SDI OPT 1 IN> terminal/<SDI OPT 2 IN> terminal.
ENGLISH - 5