Precautions for use
This product is a 12G-SDI signal compatible interface board for use installed
in a Panasonic Connect Co., Ltd. projector.
Supported projector
PT-RQ32K series, PT-RQ13K series, PT-RQ22K series
(As of March 2019)
Note
f Products other than the above may also be supported. Check the Operating Instructions of
your projector.
f If the main version of the firmware of the PT-RQ32K or PT-RQ13K is less than 3.00, this
interface board cannot be used. Update the firmware to the latest version before use. Check
the update procedure by accessing the page containing the latest information on the firmware
at the website (https://panasonic.net/cns/projector/pass/).
About the handling of the product
r Do not touch the connector section of the Interface Board
directly with your hands.
The component may be damaged by the static electricity. Handle this
product after removing the static in your body by touching the surrounding
metal, etc.
Disposal
To dispose of the product, ask your local authorities or dealer for correct
methods of disposal.
Accessories
Make sure that the following accessories are provided with your product.
Numbers enclosed in < > show the number of accessories.
Screw <4>
(XSB3+8FN)
Attention
f Appropriately discard the packaging material after unpacking the product.
f For missing accessories, consult your dealer.
f Store small parts in an appropriate manner, and keep them away from small children.
4 - ENGLISH
Precautions for use