Advertisement
FIGURE 14
1A
STEP 13:
• SECURELY assemble the GUIDE ROD SUPPORT (5) to the TOWER (1) using four RH CAPS (38), two 3/8 X 2-1/2" BOLTS
(14), four 3/8" RH WASHERS (22) and two 3/8" LOW HEIGHT LOCK NUTS (19) as shown in FIGURE 14. (NOTE: Be sure
to route cable through the hole of the GUIDE ROD SUPPORT (5) before tightening.)
• Slide GUIDE ROD BUSHINGS (29) into the tubes on the GUIDE ROD SUPPORT (5), slide 1" SHAFT COLLARS (27) under-
neath the GUIDE ROD BUSHINGS (29) and SECURELY tighten the set screws.
• Screw the threaded end of the CABLE into the end of the shaft on the HEAD PLATE (11) until the CABLE is taunt and tighten
jam nut securely. See FIGURE 13.
• Insert the WEIGHT STACK PIN (24) into the WEIGHT STACK as shown in FIGURE 13.
1/2
0
19
22
5
29
27
1/2
1
2
1/2
1/2
3
12
1
14 3/8 X 2-1/2"
TIGHTEN!
11
24
1/2
4
5
38
1/2
6
Advertisement
