Advertisement
Quick Links
INSTALLATION CERTIFICATE
The undersigned qualified installer attests to have personally fitted the here described vehicle
security system following the manufacturer instructions.
By :
ALARM KIT
932MHW
932MHW
Type of device :
&
Sold on :
SIREN 725W
................................................
&
Siren 725W
Vehicle :
..........................................................................................................................
USER AND
INSTALLER MANUAL
UK
GEMINI Technologies S.r.l.
Via Luigi Galvani 12 - 21020 Bodio Lomnago (VA) - Italia
Tel. +39 0332 943211 - Fax +39 0332 948080
www.gemini-alarm.com
Rev.00 - 01/18
ISO 9001Certified Company
Made in Italy
Advertisement
Related Manuals for Gemini 932MHW
Summary of Contents for Gemini 932MHW
- Page 1 & Siren 725W Vehicle : .......................... USER AND INSTALLER MANUAL GEMINI Technologies S.r.l. Via Luigi Galvani 12 - 21020 Bodio Lomnago (VA) - Italia Tel. +39 0332 943211 - Fax +39 0332 948080 www.gemini-alarm.com Rev.00 - 01/18 ISO 9001Certified Company...
-
Page 2: Table Of Contents
........PAGE 09 7.1 - Optical signals......................To arm the system without arming interior protection press button “3” on the Gemini remote control. PAGE 09 7.2 - Audio signals......................System arming is confirmed by a siren chirp and a flash of the turn indicators (if signals are enabled). -
Page 3: Arming Delay
CORRECT installation examples Wire tampering LED OFF (2 seconds) LED ON (1 second) 2.0 - GEMINI REMOTE CONTROL 738W AND BATTERY REPLACEMENT If the right connections have been made, the vehicle doors will lock/unlock when pressing INCORRECT installation examples the arming/disarming buttons. -
Page 4: Pinout Tables
Optical signals activated by connection to the Hazard switch will ONLY turn ON during an alarm condition (See available diagrams in the restricted area of our website: www.gemini-alam.com). ORANGE wires turn indicator flashes for all optical signaling functions (factory enabled). PAGE 07... -
Page 5: Vehicle Code Programming
After 4 more seconds, the LED will flash for the third and last time. Press the button at the 3rd flash which corresponds to number “3”. 8.0 - SYSTEM PROGRAMMING EXAMPLE 3rd FLASH Press Gemini remote control button “ ” to enable programmable functions and button Press “... -
Page 6: Ultrasonic Volumetric Protection
A quick high-pitched chirp, long low pitched chirp and 2 flashes of the turn indicators will confirm the 10.0 - LEARNING NEW DEVICES system is in programming mode. To carry out the operation successfully, make sure the required electrical connections enable the functions press once the “ON”... -
Page 7: 11.0 - Deleting Programmed Devices
11.0 - DELETING PROGRAMMED DEVICES 13.0 - TECHNICAL SPECIFICATIONS 932MHW UNIT : To carry out the operation successfully, make sure the required electrical connections (bonnet switch and ignition) are properly connected. Power supply 12Vdc If there is no bonnet switch, ground the GREEN wire (20-pin connector, pos. 15).