Configuring Sonicos For 400 Series Sonicwave Access Points; Configuring The Network Interface - SonicWALL SonicWave 200 Series Deployment Manual

Configuring SonicOS for 400 Series
SonicWave Access Points
You only need to complete three simple configuration tasks in SonicOS to prepare your SonicWave access point
to provide secure wireless access.
1

Configuring the Network Interface

2 Configuring the WLAN Zone
3 Configuring the 400 Series Access Point Settings
NOTE: For addition information, see the online help with your firewall.
Configuring the Network Interface
Each SonicWave or group of SonicWaves must be connected to a physical network interface that is configured in
a wireless zone. SonicOS provides a standard wireless zone (WLAN) which can be applied to any available
interface.
To configure the network interface in SonicOS:
1 Log into SonicOS as an administrator (default: admin / password).
2 In the MANAGE view, navigate to the System Setup | Network > Interfaces page and click Configure for
the interface to which your SonicWave is connected.
3 Select WLAN zone for the Zone type.
4 Select Static IP Mode for the Mode/IP Assignment.
5 In the IP Address field, type in any private IP address that does not interfere with the IP address range of
any other interfaces on the appliance.
6 Enter a Subnet Mask. The default is 255.255.255.0.
7 Use the default settings or select appropriate settings for the other fields and then click OK.
CAUTION: Allowing Management and User Login to the appliance from a wireless zone can pose a
security threat if you or your users have not set strong passwords.
SonicWall SonicWave Deployment Guide
Configuring SonicOS for Wireless Access
73