Configuring The Wlan Zone - SonicWALL SonicWave 200 Series Deployment Manual

Configuring the WLAN Zone

To configure the WLAN zone in SonicOS:
1 In the MANAGE view on the System Setup | Network > Zones page, click the Configure icon in the WLAN
row.
2 On the General screen, select the Allow Interface Trust option to automate the creation of Access Rules
to allow traffic to flow between the interfaces within the zone, regardless of the interfaces to which the
zone is applied.
For example, if the WLAN zone has both the X2 and X3 interfaces assigned to it, selecting Allow Interface
Trust creates the necessary access rules to allow hosts on these interfaces to communicate with each
other.
3 Select the checkboxes to enable security services on this zone. Minimally, you would select Enable
Gateway Anti-Virus Service, Enable IPS, and Enable Anti-Spyware Service. If your wireless clients are all
running SonicWall Client Anti-Virus, select Enable Client AV Enforcement Service.
4 In the Guest Services screen, optionally configure guest Internet access. For information about Guest
Services, see the SonicOS Connectivity Administration documentation.
5 In the Wireless screen under SonicWave Settings, select the desired provisioning profile from the
SonicWave Provisioning Profile drop-down list. If you added a new profile, select it here.
6 Select Only allow traffic generated by a SonicWave to allow only traffic from SonicWall wireless access
points to enter the WLAN zone interfaces, providing maximum security.
7 When finished, click OK.
SonicWall SonicWave Deployment Guide
Configuring SonicOS for Wireless Access
72