Mounting The Sonicwave 432O; Ground Connection; Mounting The Sonicwave 432O On A Pole Or Post - SonicWALL SonicWave 200 Series Deployment Manual

Mounting the SonicWave 432o

NOTE: Complete installation and mounting instructions for this product are available in translation in the
Safety and Regulatory Reference Guide for this product. See

Ground Connection

The ground connection for the SonicWave 432o is located on the back of the device.
earth cable to the grounding terminal.
To attach the green ground to earth cable to the grounding terminal:
1 Use the ground screw assembly with the star washer to attach the ground wire's ring terminal to the
SonicWave 432o. The wire should be as close to the SonicWave bottom as possible.
2 Tighten the screw securely.

Mounting the SonicWave 432o on a Pole or Post

Attach the SonicWave 432o to a surface that can support it and withstand its environment. It can be mounted to
a post or pole, and the surface material can be concrete, brick, wood, metal, or plastic.
IMPORTANT: This device must be professionally installed using either the supplied antennas or with
approved alternate antennas available from SonicWall.
1 Fasten the mounting base securely to the back of the SonicWave 432o using the provided mounting
screws.
T
2 ighten the strap with an appropriate screw driver and ensure that the device is firmly in place.
3 Attach the pole-mount bracket to the mounting base using the provided screws. The pole-mount bracket
can be attached either vertically or at a tilt of up to 30 degrees, depending on your requirements.
4 Loop the provided pole strap through the slots on the pole-mount bracket and then around the pole.
Product Safety and Regulatory
Attach the green ground to
SonicWall SonicWave <Version> Deployment Guide
Mounting Wireless Access Points
Information.
65