Graco LINE LAZER A Series Instructions And Parts List page 34

NOTE: The clutch assembly (55) includes the armature
(55a) and rotor (55b). The armature and rotor must be re-
placed together so they wear evenly.
NOTE: If the pinion assembly (138) is not yet separated
from the clutch housing, follow Steps 1 to 4. Otherwise,
start at Step 5.
1. Follow the Pressure Relief Procedure Warning on
page 4.
2. Disconnect the hose (133) from the displacement
pump.
3. Remove the bottom two screws (67) from the clutch
housing (61) and then remove the remaining three
screws (67).
Torque to 7 ft–lb (9.5 N.m)
Pinion shaft
Threaded holes
D
133
Fig. 38
Clutch
55b
156
157
55a
138
77
4. Tap lightly on the back of the bearing housing (77)
with a plastic mallet to loosen the assembly (D) from
the clutch housing (61). Pull the assembly away; the
armature (55a) will come with it.
5. Remove the armature from the pinion shaft.
6. Remove the four socket head capscrews (157) and
lockwashers (156). Install two of the screws in the
threaded holes in the rotor (55b). Alternately tighten
the screws until the rotor comes off. See Fig. 38.
7. Skip ahead to Reassembly, page 39, Step 6, or con-
tinue on the next page.
67
59
61
A
B
C
Use a steering wheel
puller to remove rotor