Graco LINE LAZER A Series Instructions And Parts List page 23

WARNING
To reduce the risk of serious bodily injury always fol-
low the Pressure Relief Procedure W arning on
page 4, before checking, adjusting, cleaning or shut-
ting down the Line Lazer.
CAUTION
For detailed engine maintenance and specifications,
refer to the separate HONDA engine manual.
Daily: Check the engine oil level and fill as necessary.
Daily: Check and fill the gas tank.
After the first 20 hours of operation and each 100
hours thereafter: Change the oil.
Fig. 20
Maintenance
Weekly: Remove the air filter cover and clean the ele-
ment. In very dusty environments, check the filter daily.
Replace the element as needed. Replacement elements
can be purchased from your local HONDA dealer.
Weekly: Check the level of the TSL in the displace-
ment pump packing nut. Fill the nut, if necessary . Keep
TSL in the nut to help lubricate the pump packings. See
page 10.
Weekly: Use a grease gun to grease the zerks (32) on
this unit. The grease purges pivot areas of paint buildup.
See Fig. 20.
Spark plug:
plug. Gap the plug to 0.025 to 0.030 in. (0.7 to 0.8 mm).
Always use a spark plug wrench.
One zerk on dual gun selector
One zerk on each gun holder
One zerk on caster lever
One zerk on caster latch
One zerk on wheel
Use only a (NGK) BP6ES or BPR6ES
02154