Second Gun And Hose Installation - Graco LINE LAZER A Series Instructions And Parts List

Second Gun and Hose Installation

NOTE: Fig. 5 represents the installation at Step 3.
NOTE: To switch the gun assemblies to the engine side
of the cart, refer to the instructions on page 18 before in-
stalling the second gun kit.
1. Disengage the trigger cable from the block (48) of the
unit's existing gun. See page 22. Engage the gun' s
trigger safety latch.
2. Loosen the carriage clamps (B, C). Slide the carriage
bar (4) off the cart.
3. For mounting the second gun bar on the pump side
of the cart: Slide a clamp (405A) onto the carriage bar
(4). Slide the carriage bar through the pump-side car-
riage clamp (B) and into the center of the cart. Now
slide another clamp (405B) onto the carriage bar .
See Fig. .
For mounting the second gun bar on the engine side
of the cart: Follow Step 3, except slide the carriage
bar through the engine-side carriage clamp (C) and
the into the center of the cart. The knobs of the
clamps (405A, 405B) must
handle bars.
4. Slide the carriage bar (4) through to the opposite car-
riage clamp. Tighten the carriage clamps (B,C).
5. Slide the second gun bar (404) far enough into the
carriage bar that the clamp (405B) engages the bar.
Position the clamps (405A, 405B) over the notches
(A) in the carriage bar (4) and tighten the clamps.
NOTE: For stable gun operation, the second
gun bar (404) has a maximum recommended
extension from the carriage bar of about
1
11- / " (286 mm).
4
DETAIL A
F
DETAIL B
34
Fig. 5
face back toward the
122
402
0010
404
402
99
94
0011
6. Disconnect the trigger cable from the second gun at
the screw (34). See Fig. 5, DETAIL B.
7. Unscrew the filter 's second outlet cap (14). Screw
the short hose (403) onto the filter nipple.
8. Remove the guide clamp screw (27).
9. Snap the cable bushing (E) into the guide plate (D).
Route the trigger cable (402) parallel with the main
gun cable, separating the guide clamp (104) to feed
the cable through it. Install and tighten the
screw (27). Route the cable through the cable guide
(7) and to the second gun.
10. Slide the hooked end of the cable (402) through the
hole (F) in the lever plate (122). Rotate and slide the
hook back until it engages the plate. See DETAIL A.
11. Reconnect the trigger cable to the second gun at
screw (34). Torque the screw to 15 in–lb (1.7 N.m),
back it off 1/16 to 1/8 turn and then tighten the jam
nut (99) while holding the screw (34). Be sure the
plate (94) moves freely.
12. Install the clip (401) to hold the cable onto the frame.
13. Connect both trigger cables to the blocks (48). Then
adjust the cable tension. See pages 21 and 22.
14. Do not install the spray tip until the system is primed.
15. Adjust simultaneous gun triggering. See page 19.
D
E
402
401
14
7
403
clamp
Torque to 15 in–lb
(1.7 N.m) then back off
1/16 to 1/8 turn
How to install cable
Correctly installed cable
27,104
C
405B
B
A
4
405A
48
02157